Newly Arrival Wire Strippers & Cable Cutters with double colors handle for Georgia Manufacturer

How To Replace Drum Brake Shoes (Full) – EricTheCarGuy

https://www.ericthecarguy.com/

Here is a full length version of a video that I posted some time ago, this way you can watch the entire thing in one sitting instead of switching from one video to the next. If your watching this for the first time I’m aware that sandals are not the best thing to wear when doing auto repair. In addition there IS a jack stand just out of frame in the video I just leave the floor jack in place while I work normally where it is so that it’s quicker to let the car down when I’m done.

—

Click below and Stay Dirty

Visit me at EricTheCarGuy.com

https://ericthecarguy.com/

Visit EricTheCarGuy Forum

https://www.ericthecarguy.com/forum/default.aspx

Visit my Facebook Page:

https://www.facebook.com/EricTheCarGuy

—

Stay dirty

ETCG

Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.

Check out the latest install video from Heatshield Products. How to Install Stainless Steel Locking Ties without Special Tools

https://www.heatshieldproducts.com/automotive/heat-shield-tape-and-fasteners/thermal-tie

Stainless steel locking ties are a great way to secure any type of high temperature insulation. There are a lot of methods and goofy tools people will try to sell you. We figured it was about time we showed everyone an easy way to install without spending extra money. You can install our Thermal-Ties (or most manufacturer’s stainless ties) using common tools already in your tool box. All you need is a pair of diagonal pliers, needle nose pliers or bent needle nose pliers.

It’s easier to start by loosely wrapping the locking tie around the pipe. Slide over your insulation, then hand tighten. Trim most of the tie off, leaving you three quarters of an inch of a tab. Use the needle nose pliers to twist the tab down and back into the tie. Repeat that process one more time, and you are done!

See how easy that was, and you didn’t have to spend money on something that will just clutter up your toolbox.

Thank you for watching,
Heatshield Products, Inc.

YouTube Channel:

https://www.youtube.com/user/HeatshieldProductsTV

Product Video:

https://youtu.be/0WumKMxqz8M

LET’S CONNECT!
Heatshield Products
– https://www.facebook.com/HeatshieldProducts
– https://www.google.com/+heatshieldproducts
– https://instagram.com/heatshieldproducts
– https://twitter.com/heatshieldprods