Hot sale Factory 7″ Forehand Round-Jaw Locking Pliers to Romania Factories

A weak link in the Dodge Grand Caravan, Town and Country, and other models is a plastic “Y pipe” heater hose fitting that begins to leak. The coolant drips directly onto the hot exhaust manifold pipe and vaporizes, resulting in coolant loss.

Often times the coolant loss will seem to be a mystery because there are no visual wet spots due to the instant vaporization. It is only when the leak becomes very bad that white smoke might be visible rising from under the hood, this is actually water vapor. This can be determined by the lack of a burning smell. The leaks often aren’t apparent unless you are looking at the fixture with the engine running at high RPM’s. The leak may be non existent or minimal at idle.

The fix is simple and inexpensive, $15 and 15 minutes. No previous auto repair experience should be necessary. You will need the following items.

Materials:
-Y-Pipe heater fitting Murray part number 84757 or equivalent.

https://www.oreillyauto.com/site/c/detail/MRY0/84757.oap

https://www.amazon.com/Four-Seasons-84757-Plastic-Splicer/dp/B000CSYSUS

https://shop.advanceautoparts.com/p/factory-air-heater-fitting-plastic-t-type-hose-splicer-84757/20891572-P

-3/4″ or larger hose clamps

-1 foot of 5/8″ Heater Hose

Tools:
-Something to cut the hose with
-Screwdriver to tighten the new hose clamps
-Pliers to help remove an old clamp

Procedure: (Follow at you own rise)

1. Some coolant will be spilled, but not much. You can drain it if you wish or just put a tray under the vehicle to catch it.

2. Install the heater hose on the singular end of the new Y-pipe with a hose clamp.

3. Use pliers to loosen the hose clamp where the old Y-pipe attaches to the motor.

4. The factory Y-pipe is held on with permanent clamps. Simply cut the two rear hoses as close to the Y-pipe as you can. Within an inch or so is good.

5. Twist the old Y pipe to break the bond where it is attached to the engine fitting, pull it off.

6. Put the new Y-pipe in place, attaching the two rear hoses. If you have trouble sliding them on then moistening and/or twisting it can help.

7. Cut the new heater hose to length and slide it onto the engine fitting.

8. Secure all fittings with hose clamps. Don’t overtighten.

9. Clean up any coolant to protect children, animals, and the environment.

10. Bask in the feeling of a job well done!

NOTE: Some people have reported using a T fitting instead of a Y shape. I don’t know if the Y shape makes any difference or not with the smooth flow of coolant. T fittings are available in metal which can reduce the potential of cracking but also introduces the possibility of corrosion. Be sure the metal will not interact with the coolant’s chemistry or with that of other metals on the vehicle.

I found this repair on the Tear it up, Fix it, Repeat blog at…

https://tearitupfixitrepeat.blogspot.com/2012/08/08-dodge-grand-caravan-antifreeze.html

gurls, i was thinking of you’s when i made this video, you can pwn any lazy-assed chicken shit man who is scared to “touch” anything to get hands dirty. Ladys watch this video, get the broken base out in half a minute, then stick the jagged part up his ass. then dont forget to subscribe, it really helps me out with this youtube gig!

ladys, please note your gender in the comments to show these assclown men who really runs the world, (except in Iran)

best broken bulb video on internets, send link to friends
6 methods of removal , simple show & tell with cut away fixture for you.
Handyman zone episode “removing broken light bulbs from fixture”
this quick video goes into detail howto remove any kind of broken light bulb from a socket without damaging the fixture or getting hurt. This is no potatoe zone o’ the handyman zone, the potatoe trick is useless and only makes a mess. Follow the tips described in this video for success in this endeavor

Light bulbs broken remove socket electric threads cross threaded stuck glass cracked stuck Thomas Edison watt flood spot halogen cfl compact florescent

6 ways to remove broken light bulb from socket video ~ how to change a light bulb, how to change a light bulb, how to change a broken light bulb, my light bulb broke in the socket, cracked light bulb, cfl broken in socket, cfl bulb YouTube Channel: https://youtube.com/user/roslynny

Handyman Dino Facebook: https://www.facebook.com/dino.pinch.7

#DinoPinch Twitter: https://twitter.com/dinopinch

@dinopinch Google+ https://plus.google.com/109791231119891562750/posts

The_Handyman_Zone Store: https://shop.spreadshirt.com/handyman/

#The_Handyman_Zone Instagram https://instagram.com/dino_the_pinch/

Buy Cool T-Shirt: https://shop.spreadshirt.com/handyman/

Adulting 101: https://www.youtube.com/channel/UCcq-S2ZayyFbM8E7jHKVi7w/feed

Hot n’ Handy Heather: https://www.youtube.com/channel/UC3PcZBVZCEELJEPwG8gyr-g

Weasel & Ferret Stuff https://www.youtube.com/channel/UCGoYhMxrJC5T4zT0-PKtQ6A