6 Years manufacturer Wire Strippers & Cable Cutters with single color handle for Russia Manufacturers
Short Description:
Product Detail
Product Tags
Innovation, quality and reliability are the core values of our company. These principles today more than ever form the basis of our success as an internationally active mid-size company for 6 Years manufacturer Wire Strippers & Cable Cutters with single color handle for Russia Manufacturers, With superb service and quality, and an enterprise of foreign trade featuring validity and competitiveness, that will be trusted and welcomed by its clients and creates happiness to its employees.
Basic Information
■Model Number: RL-YXQ001
Additional Information
■Material: A3# Steel
■Size: 8”
■Surface Treatment: Coated
■Handle: PVC
■Color: Optional
■Package: Suction Card, Tie Card, Insert Card
■OEM: Acceptable
■Samples: For FREE
■Delivery Time: Always 30 working days depending on the order quantity
■Packing: By standard cartons
Product Description
■Ningbo Rilong Hardware Tools Factory, can provide various kinds of hardware tools.
Product Image
Sometimes a simple task of flushing coolant on your Mini can be frustrating because you get stuck in a hose clip/clamp and a fun easy DIY became a night. I have another video that shows a cable tool that can be used to compress and lock those clamps but they are very specific. This video some one alternate tool.
https://www.4x4offroads.com/dana-44-locking-hubs.html
In this video I am showing you how to replace Dana 44 locking hubs with some refurbished ones.
Starting with getting the worn out Warn hub. Loosening up the screws with a hex key or allen wrench. Once the screws are loose you can get the cap off.
On the inside you can see the locking mechanism. There are two snap rings holding it. The smaller sits on the axle itself and you get it off with a small screwdriver. The outer one is a little bit more tricky to get off, but with the same screwdriver and perhaps another to assist you should be able to get it off.
Now the unit is loose and you can use two of the screws to help getting it out.
I am using a refurbished locking unit I found on eBay.
You start with the big spring and then the outer ring that fits in the grooves on the outside of the hub. It has got a castle that locks into the axle ring. You may have to turn the axle slightly to have the rings lock together.
Next comes a controlling ring with two ears that are used to push the outer ring further into the hub to free the lock. Outside of that is the ring with holes to fasten the cap.
In this case the ring is rather tight fitting so I am gently using a hammer to get it into place. It must get within the groove for the outer snapring.
Finally the snap rings are snapped into place. First the outer one and you must be sure it sits well in its place. Same with the axle snap ring it must sit nicely in its groove.
I am marking the place where the screw must sit.
The cap must be in the FREE position and you must position the “ears” of the controlling ring against the highest area of the cap – so it pushes the lock to the FREE position.
Fitting the screws in the correct place and make sure the cap sits tightly in the correct place and the screws are fastened.
Test out the locking hub by turning to the LOCK position and back again.
If the truck is jacked up you can turn the hub to confirm the axle turns with the wheel when it is in the LOCK position.
