15 Years Manufacturer Supply to Qatar

Kung Fu Maintenance shows you how to replace a leaking rotation style tub to shower diverter valve. Nice Channel Locks Set https://amzn.to/2mc5IhS
Nice Adjustable Wrench https://amzn.to/2mc4we8
Nice Ratchet Set Standard And Deep Sockets https://amzn.to/2kYetf6
Plumbers Sockets Set https://amzn.to/2lYWzwT
Terry Cloth Towel Rags https://amzn.to/2lZaFOM
Get the screwdriver used in so many KFM videos here https://amzn.to/2kHFoOF
Get the multi tool pliers used in so many KFM videos https://amzn.to/2kWTjPp
Get The Kung Fu Maintenance book here https://amzn.to/2lEQPFk
Or the Kung Fu Maintenance E book here for less than $5 https://amzn.to/2lEY8wD
Get the Kung Fu Maintenance album (good driving music) “Up Beat” here https://amzn.to/2l41pZ1
Get the Kung Fu Maintenance album (nice Instrumental music) “Entropy” here https://amzn.to/2kl2U0p
I don’t work for any of the product companies listed however I do make a small commission on items ordered through the links.

https://KungFuMaintenance.Com

https://Blog.KungFuMaintenance.Com

https://Arcade.KungFuMaintenance.Com https://VGBlog.KungFuMaintenance.Com

https://TheMaintenanceEar.KungFuMaintenance.Com

I’m going to show you how to replace a leaking diverter valve.

[WATER RUNNING]

It’s leaking right from the handle. Tighten that up. Replace this with this new one. What you do is lift this up underneath the index button. A little arrow for down. You turn it to tub, up for the shower.

Remove the screw that holds it in. Sometimes you have to wiggle it around. This one’s been leaking for a while, so great time to clean all that out there. And this just spins off. And then we can remove the extension.

And then we want to pull the whole thing out if possible, pull out the diverter. Sometimes you have to get in there with a Channellock. Don’t want to strip this end either. It looks like it could be Channellock.

Or Vice-Grips. Here is an old pair of Vice-Grips. Just clip these one the end and pull that out. There we go. And we want to reuse the washer that’s on here.

Here’s our new diverter. It’s got this stop here. We want to make sure that the stop is on the right side when we insert this. And you want to wear gloves and add plumber’s grease to the O-rings on the valve. Here’s the plumber’s grease here. And just apply the grease to the O-rings.

Put it all the way around. And then again, inserting this on the right side. Get rid of my glove now.

From https://www.kevincaron.com – In response to a viewer from Kuwait, artist Kevin Caron gives several “work arounds” for cutting metal as thick as 1/8″ without tools such as a plasma cutter or oxygen-acetylene torch. He shows various techniques using a 4-1/2″ or 7″ angle grinder with an abrasive cutting wheel, a Skilsaw, a table saw, and a Sawzall with short cutoff blades. He also shows a slick adjustable, magnetic straight edge guide that helps keep the cut straight. See more how-to videos at https://www.kevincaron.com